This product has been discontinued.

16_step, Drill, Template, Synth, DIY

Here is a scan of the 16 Step Drill Pattern. Save this image and print it out at its original size for an accurate template.

2 Comments

  1. David says:

    Hello, dont you have any pictures showing what the outputs and inputs actually are?
    I got the kit from a friend, and Ive built it with the instructions, but Id like to not have to test every output for what is where if possible.
    Also makes it faster to make my own overlay.
    And while on that topic, couldnt you supply some vectorfile of the panel without graphics instead of this, as Im sure you have a base for your own panel graphics?
    That would make a better drill guide as well.

    Otherwise, keep up the good work.

  2. Steve Harmon says:

    Hi David,

    You can found the use of the jacks on the assembly page, below the links to the assembly documents: http://www.synthrotek.com/kit-assembly-instructions/sequencer-assembly-instructions/16-step-deluxe-sequencer-assembly-instructions/

    And our graphics for the 16-Step had a large open area around many of the holes, so it wouldn’t serve as a good drill guide. Unfortunately at this time we no longer carry the 16-Step and don’t have any extra cases to make drill templates or guides from.

Leave a Reply

Your email address will not be published. Required fields are marked *